Treatment and cleaning

Treatment and cleaning of Trani Stone

Musicco company has been co-operating from years with FILA Industria chimica.

The purpose of this Method Statement is to explain uses, application methods for FILA products and the tools necessary for the best ordinary maintenance (every day) and extraordinary maintenance (periodically as needed). These instructions are for Musicco natural stone with a view to long-term preservation of the appearance of the material.

INITIAL CLEANING

The initial cleaning allows you to remove debris and construction dirt. To facilitate this operation it is recommended to remove as much as possible the fresh stucco sponge well the area during laying with clean water. Always try it before use.

Dilute CLEANER PRO in water at ratio 1:30. Apply to the floor and leave it to work for 5 minutes. Then rub the surface with an abrasive sponge or with a brush. Collect the residues and rinse with water. In case of vertical surfaces, wet a sponge with the solution. Spread it on the wall and leave it to act for 5 minutes. Then work the surface with an abrasive sponge, collect the residues and rinse with water.

ANTISTAINS PROTECTION

After the clearing, when the surface is dry, we suggest to proceed with the application of a water base anti stain sealer. I twill reduce the absorption of water and non acid staining agents without changing the look of the tiles.

Using a paintbrush, apply FILAMP90 ECO PLUS evenly and continually to a clean dry surface. Wait 15 minutes, then remove any residues with a cloth. Wait 4 hours before walking on the surface and 24 hours before wetting it.

Carry out a patch test on a small surface area to check for any changes in color. It does not protect against acids.

ORDINARY MAINTENANCE

In order to carry out correct routine maintenance, we recommend that you always use neutral detergents. These, properly used, allow you to clean the area without damaging or fattening it. We recommend washing at least weekly in order to avoid important organic build-up.

Dilute 3 caps of FILACLEANER in 5 liters of water; Impregnate a cloth with the solution, wring it and pass it on the surface.   Leave to dry. At this dilution it is possible to use a washer-dryer machine. In case of tops, we suggest the use of BRIO.

For a correct treatment see the complete data sheet.

More than a century of experience

since 1908

in the wonderful city of Trani in southern Italy

Extraction and Processing

of Trani Stone

Processing of limestone extracted directly from our quarries

Respect for nature

Ecology is not a detail for us

The company constantly works with a vigilant eye to ecology and care of the environment by committing to comply with the applicable both for the disposal of solid waste and the water used.